Mould Inserts are another addition
from our stables. The very nature of the components that roll out
from our establishments assures firm insertions to avoid any kind
of sparking while in operation. Mould Inserts do not corrugate to
interrupt supply and total assurance in provided to the components
to which they are connected. Mould Inserts are used as anchors in some equipment to hold cables and wires at one end for tension management of the cables.They assure firm grip to avoid any kind of loss while in operation. We use MS and brass in manufacturing
Mould Inserts for their sturdy ness and assured longevity.
Brass Inserts for Rubber & Plastic Pipe Moulding
Nylon Tube Moulding Insert
Application :
For High tension wiring and cabling - peculiar dimensional circuited power supply with cabling - electric and mechanical gadgets etc.
Material Used :
Brass rods are hollowed and moulded in their manufacturing. They are sturdy and assure longevity.
Finish :
Cut brass rod and pipes are shined or buffed with matty finish - nickel and SS plating or also possible on requirements.
Application : 